My self-made 3D-printable designs, mainly in OpenSCAD
Vous ne pouvez pas sélectionner plus de 25 sujets Les noms de sujets doivent commencer par une lettre ou un nombre, peuvent contenir des tirets ('-') et peuvent comporter jusqu'à 35 caractères.

Display Holder.scad 1.7KB

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172
  1. /*
  2. * Created by:
  3. * Thomas Buck <xythobuz@xythobuz.de> in March 2016
  4. *
  5. * Licensed under the Creative Commons - Attribution license.
  6. */
  7. // -----------------------------------------------------------
  8. $fn = 25;
  9. height = 10;
  10. // works properly from around 40 to 80 degrees
  11. display_angle = 60; // in degrees
  12. // "right", "left", "both" or "none"
  13. hole_position = "right";
  14. hole_diameter = 2.9;
  15. // -----------------------------------------------------------
  16. module holder() {
  17. // front part
  18. translate([10, 0, 0])
  19. difference() {
  20. translate([-13 + (5 * sin(display_angle - 45)),
  21. -6 - (3 * sin(display_angle - 45)), 0])
  22. rotate([0, 0, display_angle])
  23. cube([13, 6, height]);
  24. // cut off top edge
  25. translate([-15, 5, 0])
  26. cube([10, 3, height]);
  27. }
  28. // upper body
  29. translate([0, 0, 0])
  30. cube([10, 5, height]);
  31. // lower body
  32. translate([5, -24, 0])
  33. cube([4, 24, height]);
  34. // upper border
  35. translate([10, 0, 0])
  36. cube([7, 5, height]);
  37. // upper lip
  38. translate([14, -5, 0])
  39. cube([3, 5, height]);
  40. // lower border
  41. translate([9, -24, 0])
  42. cube([3, 3, height]);
  43. }
  44. difference() {
  45. holder();
  46. // insert holes
  47. if ((hole_position == "right") || (hole_position == "both")) {
  48. rotate([0, 90, 90 + display_angle])
  49. translate([-8, -0.5 + (4 * sin(display_angle - 45)), -4])
  50. cylinder(d=hole_diameter, h=10);
  51. }
  52. if ((hole_position == "left") || (hole_position == "both")) {
  53. rotate([0, 90, 90 + display_angle])
  54. translate([-2, -0.5 + (4 * sin(display_angle - 45)), -4])
  55. cylinder(d=hole_diameter, h=10);
  56. }
  57. }