123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172 |
- /*
- * Created by:
- * Thomas Buck <xythobuz@xythobuz.de> in March 2016
- *
- * Licensed under the Creative Commons - Attribution license.
- */
-
- // -----------------------------------------------------------
-
- $fn = 25;
-
- height = 10;
-
- // works properly from around 40 to 80 degrees
- display_angle = 60; // in degrees
-
- // "right", "left", "both" or "none"
- hole_position = "right";
- hole_diameter = 2.9;
-
- // -----------------------------------------------------------
-
- module holder() {
- // front part
- translate([10, 0, 0])
- difference() {
- translate([-13 + (5 * sin(display_angle - 45)),
- -6 - (3 * sin(display_angle - 45)), 0])
- rotate([0, 0, display_angle])
- cube([13, 6, height]);
-
- // cut off top edge
- translate([-15, 5, 0])
- cube([10, 3, height]);
- }
-
- // upper body
- translate([0, 0, 0])
- cube([10, 5, height]);
-
- // lower body
- translate([5, -24, 0])
- cube([4, 24, height]);
-
- // upper border
- translate([10, 0, 0])
- cube([7, 5, height]);
-
- // upper lip
- translate([14, -5, 0])
- cube([3, 5, height]);
-
- // lower border
- translate([9, -24, 0])
- cube([3, 3, height]);
- }
-
- difference() {
- holder();
-
- // insert holes
- if ((hole_position == "right") || (hole_position == "both")) {
- rotate([0, 90, 90 + display_angle])
- translate([-8, -0.5 + (4 * sin(display_angle - 45)), -4])
- cylinder(d=hole_diameter, h=10);
- }
- if ((hole_position == "left") || (hole_position == "both")) {
- rotate([0, 90, 90 + display_angle])
- translate([-2, -0.5 + (4 * sin(display_angle - 45)), -4])
- cylinder(d=hole_diameter, h=10);
- }
- }
|