Removed Delta from the default config file.

Changed EEPROM CHITCHAT behavior. M503 is always enabled.

Marlin/Configuration.h

@@ -70,46 +70,6 @@
 
 #define POWER_SUPPLY 1
 
-
-//===========================================================================
-//============================== Delta Settings =============================
-//===========================================================================
-// Enable DELTA kinematics
-//#define DELTA
-
-// Make delta curves from many straight lines (linear interpolation).
-// This is a trade-off between visible corners (not enough segments)
-// and processor overload (too many expensive sqrt calls).
-#define DELTA_SEGMENTS_PER_SECOND 200
-
-// Center-to-center distance of the holes in the diagonal push rods.
-#define DELTA_DIAGONAL_ROD 250.0 // mm
-
-// Horizontal offset from middle of printer to smooth rod center.
-#define DELTA_SMOOTH_ROD_OFFSET 175.0 // mm
-
-// Horizontal offset of the universal joints on the end effector.
-#define DELTA_EFFECTOR_OFFSET 33.0 // mm
-
-// Horizontal offset of the universal joints on the carriages.
-#define DELTA_CARRIAGE_OFFSET 18.0 // mm
-
-// Effective horizontal distance bridged by diagonal push rods.
-#define DELTA_RADIUS (DELTA_SMOOTH_ROD_OFFSET-DELTA_EFFECTOR_OFFSET-DELTA_CARRIAGE_OFFSET)
-
-// Effective X/Y positions of the three vertical towers.
-#define SIN_60 0.8660254037844386
-#define COS_60 0.5
-#define DELTA_TOWER1_X -SIN_60*DELTA_RADIUS // front left tower
-#define DELTA_TOWER1_Y -COS_60*DELTA_RADIUS
-#define DELTA_TOWER2_X SIN_60*DELTA_RADIUS // front right tower
-#define DELTA_TOWER2_Y -COS_60*DELTA_RADIUS
-#define DELTA_TOWER3_X 0.0 // back middle tower
-#define DELTA_TOWER3_Y DELTA_RADIUS
-
-// Diagonal rod squared
-#define DELTA_DIAGONAL_ROD_2 pow(DELTA_DIAGONAL_ROD,2)
-
 //===========================================================================
 //=============================Thermal Settings  ============================
 //===========================================================================

Marlin/ConfigurationStore.cpp

@@ -94,7 +94,7 @@ void Config_StoreSettings()
 #endif //EEPROM_SETTINGS
 
 
-#ifdef EEPROM_CHITCHAT
+#ifndef DISABLE_M503
 void Config_PrintSettings()
 {  // Always have this function, even with EEPROM_SETTINGS disabled, the current values will be shown
     SERIAL_ECHO_START;
@@ -231,7 +231,9 @@ void Config_RetrieveSettings()
     {
         Config_ResetDefault();
     }
-    Config_PrintSettings();
+    #ifdef EEPROM_CHITCHAT
+      Config_PrintSettings();
+    #endif
 }
 #endif
 

Marlin/ConfigurationStore.h

@@ -5,7 +5,7 @@
 
 void Config_ResetDefault();
 
-#ifdef EEPROM_CHITCHAT
+#ifndef DISABLE_M503
 void Config_PrintSettings();
 #else
 FORCE_INLINE void Config_PrintSettings() {}