Bo Herrmannsen 9 роки тому
джерело
коміт
4aa2490099
1 змінених файлів з 0 додано та 9 видалено
  1. 0
    9
      Documentation/RampsServoPower.md

+ 0
- 9
Documentation/RampsServoPower.md Переглянути файл

@@ -1,9 +0,0 @@
1
-
2
-
3
-__Note for RAMPS users:__
4
-----------------------
5
-
6
--By default, RAMPS have no power on servo bus (if you happen to have a multimeter, check the voltage on servo power pins).
7
--In order to get the servo working, you need to supply 5V to 5V pin.. You can do it using your power supply (if it has a 5V output) or jumping the "Vcc" from Arduino to the 5V RAMPS rail.
8
--These 2 pins are located just between the Reset Button and the yellow fuses... There are marks in the board showing 5V and VCC.. just connect them..
9
--If jumping the arduino Vcc do RAMPS 5V rail, take care to not use a power hungry servo, otherwise you will cause a blackout in the arduino board ;-)

Завантаження…
Відмінити
Зберегти