|
@@ -481,18 +481,22 @@
|
481
|
481
|
// before a min_temp_error is triggered. (Shouldn't be more than 10.)
|
482
|
482
|
//#define MAX_CONSECUTIVE_LOW_TEMPERATURE_ERROR_ALLOWED 0
|
483
|
483
|
|
484
|
|
-// The number of milliseconds a hotend will preheat before starting to check
|
485
|
|
-// the temperature. This value should NOT be set to the time it takes the
|
486
|
|
-// hot end to reach the target temperature, but the time it takes to reach
|
487
|
|
-// the minimum temperature your thermistor can read. The lower the better/safer.
|
488
|
|
-// This shouldn't need to be more than 30 seconds (30000)
|
|
484
|
+/**
|
|
485
|
+ * The number of milliseconds a hotend will preheat before starting to check
|
|
486
|
+ * the temperature. This value should NOT be set to the time it takes the
|
|
487
|
+ * hot end to reach the target temperature, but the time it takes to reach
|
|
488
|
+ * the minimum temperature your thermistor can read. The lower the better/safer.
|
|
489
|
+ * This shouldn't need to be more than 30 seconds (30000)
|
|
490
|
+ */
|
489
|
491
|
//#define MILLISECONDS_PREHEAT_TIME 0
|
490
|
492
|
|
491
|
493
|
// @section extruder
|
492
|
494
|
|
493
|
|
-// Extruder runout prevention.
|
494
|
|
-// If the machine is idle and the temperature over MINTEMP
|
495
|
|
-// then extrude some filament every couple of SECONDS.
|
|
495
|
+/**
|
|
496
|
+ * Extruder runout prevention.
|
|
497
|
+ * If the machine is idle and the temperature over MINTEMP
|
|
498
|
+ * then extrude some filament every couple of SECONDS.
|
|
499
|
+ */
|
496
|
500
|
//#define EXTRUDER_RUNOUT_PREVENT
|
497
|
501
|
#if ENABLED(EXTRUDER_RUNOUT_PREVENT)
|
498
|
502
|
#define EXTRUDER_RUNOUT_MINTEMP 190
|