Slightly tweaked config to home with worse heated print bed cable routing. make sure you're under z 70mm before homing with these settings

Marlin/Configuration.h

@@ -589,7 +589,7 @@
 
 // @section homing
 
-#define Z_HOMING_HEIGHT 0  // (in mm) Minimal z height before homing (G28) for Z clearance above the bed, clamps, ...
+#define Z_HOMING_HEIGHT 10  // (in mm) Minimal z height before homing (G28) for Z clearance above the bed, clamps, ...
                              // Be sure you have this distance over your Z_MAX_POS in case.
 
 // ENDSTOP SETTINGS:
@@ -734,7 +734,7 @@
 #define Z_SAFE_HOMING
 
 #if ENABLED(Z_SAFE_HOMING)
-  #define Z_SAFE_HOMING_X_POINT (25)    // X point for Z homing when homing all axis (G28).
+  #define Z_SAFE_HOMING_X_POINT (30)    // X point for Z homing when homing all axis (G28).
   #define Z_SAFE_HOMING_Y_POINT (MANUAL_Y_HOME_POS)    // Y point for Z homing when homing all axis (G28).
 #endif