probe settings changed

Marlin/Configuration.h

@@ -987,8 +987,7 @@
  *     |    [-]    |
  *     O-- FRONT --+
  */
-//define NOZZLE_TO_PROBE_OFFSET { -37, 2, -3.04 }
-#define NOZZLE_TO_PROBE_OFFSET { -37, 2, -3 }
+#define NOZZLE_TO_PROBE_OFFSET { -37, 2, -3.04 }
 
 // Most probes should stay away from the edges of the bed, but
 // with NOZZLE_AS_PROBE this can be negative for a wider probing area.
@@ -1262,7 +1261,7 @@
   // For Cartesian machines, instead of dividing moves on mesh boundaries,
   // split up moves into short segments like a Delta. This follows the
   // contours of the bed more closely than edge-to-edge straight moves.
-  #define SEGMENT_LEVELED_MOVES
+  //#define SEGMENT_LEVELED_MOVES
   #define LEVELED_SEGMENT_LENGTH 5.0 // (mm) Length of all segments (except the last one)
 
   /**
@@ -1271,8 +1270,8 @@
   #define G26_MESH_VALIDATION
   #if ENABLED(G26_MESH_VALIDATION)
     #define MESH_TEST_NOZZLE_SIZE    0.4  // (mm) Diameter of primary nozzle.
-    #define MESH_TEST_LAYER_HEIGHT   0.2  // (mm) Default layer height for the G26 Mesh Validation Tool.
-    #define MESH_TEST_HOTEND_TEMP  205    // (°C) Default nozzle temperature for the G26 Mesh Validation Tool.
+    #define MESH_TEST_LAYER_HEIGHT   0.1  // (mm) Default layer height for the G26 Mesh Validation Tool.
+    #define MESH_TEST_HOTEND_TEMP  200    // (°C) Default nozzle temperature for the G26 Mesh Validation Tool.
     #define MESH_TEST_BED_TEMP      60    // (°C) Default bed temperature for the G26 Mesh Validation Tool.
     #define G26_XY_FEEDRATE         20    // (mm/s) Feedrate for XY Moves for the G26 Mesh Validation Tool.
     #define G26_RETRACT_MULTIPLIER   1.0  // G26 Q (retraction) used by default between mesh test elements.
@@ -1293,13 +1292,13 @@
 
     // Beyond the probed grid, continue the implied tilt?
     // Default is to maintain the height of the nearest edge.
-    #define EXTRAPOLATE_BEYOND_GRID
+    //#define EXTRAPOLATE_BEYOND_GRID
 
     //
     // Experimental Subdivision of the grid by Catmull-Rom method.
     // Synthesizes intermediate points to produce a more detailed mesh.
     //
-    #define ABL_BILINEAR_SUBDIVISION
+    //#define ABL_BILINEAR_SUBDIVISION
     #if ENABLED(ABL_BILINEAR_SUBDIVISION)
       // Number of subdivisions between probe points
       #define BILINEAR_SUBDIVISIONS 3