SDCARDDETECTINVERTED problems

Fixed an error where SDCARDDETECTINVERTED was being defined/undefined
improperly

Marlin/Conditionals.h

@@ -322,7 +322,7 @@
     #define STEPS_PER_CUBIC_MM_E (axis_steps_per_unit[E_AXIS] / EXTRUSION_AREA)
   #endif
 
-  #ifdef ULTIPANEL
+  #if defined(ULTIPANEL) && !defined(ELB_FULL_GRAPHIC_CONTROLLER)
     #undef SDCARDDETECTINVERTED
   #endif
 

Marlin/Configuration_adv.h

@@ -289,7 +289,9 @@
   // You can get round this by connecting a push button or single throw switch to the pin defined as SDCARDCARDDETECT
   // in the pins.h file.  When using a push button pulling the pin to ground this will need inverted.  This setting should
   // be commented out otherwise
-  #define SDCARDDETECTINVERTED
+  #ifndef ELB_FULL_GRAPHIC_CONTROLLER
+    #define SDCARDDETECTINVERTED
+  #endif
 
   #define SD_FINISHED_STEPPERRELEASE true  //if sd support and the file is finished: disable steppers?
   #define SD_FINISHED_RELEASECOMMAND "M84 X Y Z E" // You might want to keep the z enabled so your bed stays in place.