|
@@ -491,14 +491,13 @@ const bool Z_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the logic
|
491
|
491
|
|
492
|
492
|
#endif
|
493
|
493
|
|
494
|
|
-// Seaparte concurrent Z Probe and Z min endstop support
|
|
494
|
+// Support for concurrent and seperate Z Probe and Z min endstop use.
|
495
|
495
|
// Added by Chris Roadfeldt 3-28-2015
|
496
|
|
-// If you have a Z Probe in addition to a Z min endstop, uncomment the #define Z_PROBE_AND_ENDSTOP line below and configure Z Probe settings.
|
497
|
|
-// Only use this if you have both a Z PROBE and Z Min ENDSTOP.
|
498
|
|
-// Note: It's expected that your Z Probe triggers in the direction towards your bed.
|
|
496
|
+// If you would like to use both a Z Probe and a Z min endstop at the same time, uncomment #define Z_PROBE_AND_ENDSTOP below
|
|
497
|
+// You will want to disable Z_SAFE_HOMING above as you will still use the Z min endstop for homing.
|
499
|
498
|
// In order to use this, you must have a Z_PROBE_PIN defined in the pins.h file for your control board.
|
500
|
499
|
// RAMPS 1.3/1.4 boards may be able to use the 5V, Ground and the D32 pin in the Aux 4 section of the RAMPS board for the signal.
|
501
|
|
-// The D32 pin in Aux 4 on RAMPS maps to the Arduino D32 pin. The Z_PROBE_PIN is setting the pin to use on the Arduino. Since the D32 pin on the RAMPS maps to D32 on Arduino, this works.
|
|
500
|
+// The D32 pin in Aux 4 on RAMPS maps to the Arduino D32 pin. Z_PROBE_PIN is setting the pin to use on the Arduino. Since the D32 pin on the RAMPS maps to D32 on Arduino, this works.
|
502
|
501
|
// D32 is currently selected in the RAMPS 1.3/1.4 pin file. Update the pins.h file for your control board to make use of this. Not doing so nullifies Z_PROBE_AND_ENDSTOP
|
503
|
502
|
// WARNING: Setting the wrong pin may have unexpected and disastrous outcomes. Use with caution and do your homework.
|
504
|
503
|
// #define Z_PROBE_AND_ENDSTOP
|