・More ANALOG NUMBERING to Analog Input
・Add comment header to all the section of all the pins files

・Sort sections as follows:
1. Some special definitions (USBCON, LARGE_FLASH, etc)
2. Servos
3. Limit Switches
4. Z Probe
5. Steppers
6. Temperature Sensors
7. Heaters / Fans
8. Misc. Functions
9. LCD / Controller

・Move MAX6675_SS into "Temperature Sensors" section
・Adjust spacing

Some other pins formatting also

The support for reprapworld LCD boke the code for the REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER. See Full Grapics Display does not work any more after #4408  #4439

Includes:
  *firmware version / branch / date.
  *extruder count
  *board information (name, serial details, power supply type)
  *thermistors (names, min/max temperatures)
  *printer statistics (PRINTCOUNTER details)

Thanks to @thinkyhead for contributions.

SERVO2 is doubled defined and causes compiler errors

Following up on #3231

Keep "astyled" reformatting

- `SD_DETECT_PIN` replaces `SDCARDDETECT`
- `SD_DETECT_INVERTED` replaces `SDCARDDETECTINVERTED`
- Revise the description of `SD_DETECT_INVERTED`
- Add a note about the override of `SD_DETECT_INVERTED` in
`Conditionals.h`

- Rename the pin so it can be tested with `PIN_EXISTS`
- Fix some incorrect tests for `SDCARDDETECT`

For consistency with other pins, allowing use of `PIN_EXISTS` macro.

Apply `ENABLED` / `DISABLED` / `HAS_SERVOS` macros to pins files.

The encrot values are used in only one place, and don’t vary, so remove
redundant references.

- Naive implementation, assuming the data sheet pin numbers correspond
to Arduino pin numbers.

Extruder 2 and 3 was swapped

Also fix analogInputToDigitalPin so it uses proper C hex notation

There’s no need to ask users to uncomment Max Endstop pins when they
have them. These will be set to -1 later if the endstop option is
disabled.

Hopefully this is helpful to organization and future expansion….

There’s no need to ask users to uncomment Max Endstop pins when they
have them. These will be set to -1 later if the endstop option is
disabled.

Hopefully this is helpful to organization and future expansion….

There’s no need to ask users to uncomment Max Endstop pins when they
have them. These will be set to -1 later if the endstop option is
disabled.

Hopefully this is helpful to organization and future expansion….