・More ANALOG NUMBERING to Analog Input
・Add comment header to all the section of all the pins files

・Sort sections as follows:
1. Some special definitions (USBCON, LARGE_FLASH, etc)
2. Servos
3. Limit Switches
4. Z Probe
5. Steppers
6. Temperature Sensors
7. Heaters / Fans
8. Misc. Functions
9. LCD / Controller

・Move MAX6675_SS into "Temperature Sensors" section
・Adjust spacing

See #4316

Supports both dual and single head printers (with the correct config).
Includes community sourced feed rate fix.

Rename / move files.

Remove redundant definitions.

Includes:
  *firmware version / branch / date.
  *extruder count
  *board information (name, serial details, power supply type)
  *thermistors (names, min/max temperatures)
  *printer statistics (PRINTCOUNTER details)

Thanks to @thinkyhead for contributions.

Following up on #3231

For consistency with other pins, allowing use of `PIN_EXISTS` macro.

Apply `ENABLED` / `DISABLED` / `HAS_SERVOS` macros to pins files.

- Patched up for most included configurations

- K8200 uses a non-standard RAMPS with Z_ENABLE=63 ??
- Assuming from previous input that 3DRAG is the same.

There’s no need to ask users to uncomment Max Endstop pins when they
have them. These will be set to -1 later if the endstop option is
disabled.

Hopefully this is helpful to organization and future expansion….

There’s no need to ask users to uncomment Max Endstop pins when they
have them. These will be set to -1 later if the endstop option is
disabled.

Hopefully this is helpful to organization and future expansion….

There’s no need to ask users to uncomment Max Endstop pins when they
have them. These will be set to -1 later if the endstop option is
disabled.

Hopefully this is helpful to organization and future expansion….