This allows PID_FUNCTIONAL_RANGE to use a maximum duty cycle higher
than PID_MAX. This is useful for powerful heaters to heat quickly in
bang-bang mode, but use a lower duty cycle that is easier to stabilize
in PID mode.

Found some unwanted html at the bottom of the file which caused it to not be able to compile.
Also added rumba as machine.

Fix step rate bug (especially for retraction)

Generated with createTemperatureLookup.py. The old table crapped out at
270C, which was a problem for polycarbonate.

These definition contain also the definition for the graphics LCD.

Definition for the graphic LCD are already in it, they will not harm the
configuration as they are only defined constants

Update Polish language 	#define MSG_RESUMING "Wznawiam drukowanie"

Fix to a bug that I just introduced - sorry. Forgot about offset of string length.

Add SD-Card change and SD-Card init. for reprap electronics without
SD-Chard change detect pin.

Use all available characters in narrow LCDs < 20 characters.

Fix to a minor bug with hardcoded LCD_WIDTH that draws edited values outside of the 16 characters width LCDs.

The extruder offset can be specified in the configuration
file or adjusted on the fly using the "M218 T# X# Y#" command.
The EEPROM support is not yet merged in.
The "T#" command can take option "F#" that specifies the feedrate
at which the printing head should be re-positioned. If not
specified the re-positioning move is not preformed immediately,
but the coordinates are adjusted for the printer to properly
position the head when the next movement happens.

This reverts commit 01541ee64c.

[default off for now]
syntax: M600  X[pos] Y[pos] Z[relative lift] E[initial retract] L[later retract distance for removal]

if enabled, after a M600, the printer will retract by E, lift by Z, move to XY, retract even more filament.
Oh, and it will display "remove filament" and beep like crazy.

You are then supposed to insert a new filament (other color, e.g.) and click the display to continue.
After having the nozzle cleaned manually, aided by the disabled e-steppers.
After clicking, the printer will then go back the whole shebang, and continue printing with a fancy new color.

Add a feature to run the cooling fan at full speed for a small period
(default 100ms) when first starting the fan.  Some fans wont reliably
start spinning at low power, and many fans have issue with the PWM at
low power.  However, once the fan starts spinning it can reliably be
set to a wide range of PWM values.

Always set the FAN PWM value in check_axes_activity() and always use
the value of the active move if a move is active.