- `per_sq_second` => `per_s2`
- `per_sqr_second` => `per_s2`
- `axis_steps_per_sqr_second` => `max_acceleration_steps_per_s2`

This is an update of MarlinDev PR #196.

G20/21: support for switching input units between millimeters and
inches.
M149: support for changing input temperature units.

In support of these changes, code_value() and code_value_short() are
replaced with an array of functions which handle converting to the
proper types and/or units.

Follow-up the PR #3643(Temperature singleton)

・Change from fanSpeedSoftPwm[0] to thermalManager.fanSpeedSoftPwm[0] in planner.cpp
It fix compilation error when FAN_SOFT_PWM is enabled.

・Remove declaration of setExtruderAutoFanState() in temperature.h
Because that function was abolished.

・Change from babystepsTodo to thermalManager.babystepsTodo in ultralcd.cpp
It fix compilation errors when BABYSTEPPING is enabled.

- Search all symbols and apply prefixes where needed
- Encapsulate some private methods
- Inline some setters
- Make `microstep_mode` a public method

Only measure and store filament width when E is going forward.

Following up on #3231

Sorting ot what else belongs to what if was not so hard.
But the static `ms = ms = millis();` was a bit surpising.

See: https://github.com/Ultimaker/Marlin/pull/7

Apply `constrain`, `NOMORE`, `NOLESS` and `CRITICAL_SECTION` macros
wherever possible.

Redo of #2939 rebased against RCBugFix

st_set_position takes long
```void st_set_position(const long& x, const long& y, const long& z, const long& e)```

anything is long, we don't need float there

dx -> dsx
dy -> dsy
dz -> dsz
de -> dse

Keep "astyled" reformatting

As noted by @darkjavi et.al. in #103, the E1 motor was not being enabled in planner.cpp when using DUAL_X_CARRIAGE. This patch enables and disables E1 as it should.

With the introduction of the #if ENABLED(…)

reads better than