I recently upgraded my Marlin to V1.1.x and decided to publish my fix to make marlin compile properly when #define board megatronics 2 in combination with #define reprapworld keypad v1.1. It was previously described in the comments of a closed pull request. MarlinFirmware#472. All the buttons on the keypad are now operational.

・More ANALOG NUMBERING to Analog Input
・Add comment header to all the section of all the pins files

・Sort sections as follows:
1. Some special definitions (USBCON, LARGE_FLASH, etc)
2. Servos
3. Limit Switches
4. Z Probe
5. Steppers
6. Temperature Sensors
7. Heaters / Fans
8. Misc. Functions
9. LCD / Controller

・Move MAX6675_SS into "Temperature Sensors" section
・Adjust spacing

Some other pins formatting also

Includes:
  *firmware version / branch / date.
  *extruder count
  *board information (name, serial details, power supply type)
  *thermistors (names, min/max temperatures)
  *printer statistics (PRINTCOUNTER details)

Thanks to @thinkyhead for contributions.

Following up on #3231

- `SD_DETECT_PIN` replaces `SDCARDDETECT`
- `SD_DETECT_INVERTED` replaces `SDCARDDETECTINVERTED`
- Revise the description of `SD_DETECT_INVERTED`
- Add a note about the override of `SD_DETECT_INVERTED` in
`Conditionals.h`

- Rename the pin so it can be tested with `PIN_EXISTS`
- Fix some incorrect tests for `SDCARDDETECT`

For consistency with other pins, allowing use of `PIN_EXISTS` macro.

The encrot values are used in only one place, and don’t vary, so remove
redundant references.

There’s no need to ask users to uncomment Max Endstop pins when they
have them. These will be set to -1 later if the endstop option is
disabled.

Hopefully this is helpful to organization and future expansion….

There’s no need to ask users to uncomment Max Endstop pins when they
have them. These will be set to -1 later if the endstop option is
disabled.

Hopefully this is helpful to organization and future expansion….

There’s no need to ask users to uncomment Max Endstop pins when they
have them. These will be set to -1 later if the endstop option is
disabled.

Hopefully this is helpful to organization and future expansion….