1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556 |
- /**
- * Marlin 3D Printer Firmware
- * Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
- *
- * Based on Sprinter and grbl.
- * Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
- *
- * This program is free software: you can redistribute it and/or modify
- * it under the terms of the GNU General Public License as published by
- * the Free Software Foundation, either version 3 of the License, or
- * (at your option) any later version.
- *
- * This program is distributed in the hope that it will be useful,
- * but WITHOUT ANY WARRANTY; without even the implied warranty of
- * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
- * GNU General Public License for more details.
- *
- * You should have received a copy of the GNU General Public License
- * along with this program. If not, see <https://www.gnu.org/licenses/>.
- *
- */
- #pragma once
-
- /**
- * Test STM32-specific configuration values for errors at compile-time.
- */
- //#if ENABLED(SPINDLE_LASER_PWM) && !(SPINDLE_LASER_PWM_PIN == 4 || SPINDLE_LASER_PWM_PIN == 6 || SPINDLE_LASER_PWM_PIN == 11)
- // #error "SPINDLE_LASER_PWM_PIN must use SERVO0, SERVO1 or SERVO3 connector"
- //#endif
-
- #if ENABLED(FAST_PWM_FAN) || SPINDLE_LASER_FREQUENCY
- #error "Features requiring Hardware PWM (FAST_PWM_FAN, SPINDLE_LASER_FREQUENCY) are not yet supported on STM32."
- #endif
-
- #if ENABLED(SDCARD_EEPROM_EMULATION) && DISABLED(SDSUPPORT)
- #undef SDCARD_EEPROM_EMULATION // Avoid additional error noise
- #if USE_FALLBACK_EEPROM
- #warning "EEPROM type not specified. Fallback is SDCARD_EEPROM_EMULATION."
- #endif
- #error "SDCARD_EEPROM_EMULATION requires SDSUPPORT. Enable SDSUPPORT or choose another EEPROM emulation."
- #endif
-
- #if defined(STM32F4xx) && BOTH(PRINTCOUNTER, FLASH_EEPROM_EMULATION)
- #warning "FLASH_EEPROM_EMULATION may cause long delays when writing and should not be used while printing."
- #error "Disable PRINTCOUNTER or choose another EEPROM emulation."
- #endif
-
- #if !defined(STM32F4xx) && ENABLED(FLASH_EEPROM_LEVELING)
- #error "FLASH_EEPROM_LEVELING is currently only supported on STM32F4 hardware."
- #endif
-
- #if ENABLED(SERIAL_STATS_MAX_RX_QUEUED)
- #error "SERIAL_STATS_MAX_RX_QUEUED is not supported on this platform."
- #elif ENABLED(SERIAL_STATS_DROPPED_RX)
- #error "SERIAL_STATS_DROPPED_RX is not supported on this platform."
- #endif
|