OpenChrono

OpenChrono

Chronograph for Airsoft use, released as Free Open Source hardware and software!

Uses a 3D printed housing to hold an Arduino, an OLED display, batteries and two photosensitive IR light barriers.

Fixed mounting on the front of the gun in the style of a silencer.

Can optionally also include UV LEDs to illuminate tracer BBs.

Hardware

Use the included OpenSCAD design file in hardware/openchrono.scad to render your own custom STLs that fit your use-case.

Required Parts

Besides some common stuff like soldering wire and hotglue you need the following parts to build this project.

Description	Type	Count
Arduino Nano		1x
LCD 128x64 I2C	SSD1306 0.96”	1x
Slide Switch		1x
IR Phototransistor	SFH 309 FA-5	2x
IR LED 3mm		2x
Resistor	1k Ohm	2x
Resistor	100 Ohm	1x
Screw	M2 10mm	4x
Screw	M2.5 10mm	2x
Screw	M3 16mm	8x
Heatmelt Insert	M3 <= 10mm	8x

For the UV tracer option you also need the following parts.

Description	Type	Count
UV LED 3mm		2x
Resistor	100 Ohm	1x

You have different options for powering the project. My first version for testing uses a pre-made AA battery holder.

Description	Type	Count
AA Battery		3x
AA Bat. Holder		1x
Screw (sunk)	M3 6mm	2x

The originally intended variant is a AAA battery holder printed into the model. I don’t have the terminals for that yet so it is not finished.

Description	Type	Count
AAA Battery		3x
Bat. Terminal Neg.		3x
Bat. Terminal Pos.		3x

I’m also looking to design a LiPo version with charger included in the future.

Software

This project uses the U8g2 library by olikraus to draw to the I2C OLED display.

You can compile and flash the software using either PlatformIO or the standard Arduino IDE.

With the Arduino IDE install the U8g2 library using the Library Manager and then flash as usual.

For PlatformIO run something like the following command.

pio run -t upload --upload-port /dev/ttyUSB0

Replace /dev/ttyUSB0 with the port you are using.

Configuration

Take a look at firmware/OpenChrono/config.h. This file contains all the settings you can change as a user.

The most important setting is SENSOR_DISTANCE, which is given from the 3D model of the case. It is echoed when rendering the OpenSCAD design.

You can set BB_WEIGHT to the one you use most commonly, and BB_WEIGHTS to others interesting for you (BB_WEIGHTS should include BB_WEIGHT). These values are used to calculate the energy in Joules.

Set PREFERRED_UNITS to what you would like to see in the 2D graph.

The range of speeds that can be measured is determined by TIMER_PRESCALER. Take a look at the comment in firmware/OpenChrono/ticks.cpp for details.