[1.1.x] Cleanup for SD Print Again

Followup to #8123 - to match 2.0.x changes

[1.1.x] Dual endstops XYZ

* Fixed M303 thermal protection

The temperature sanity checking logic was not being applied during M303
(pid autotuning) because instead of setting a target temperature, it
directly manipulated the pwm values.  When PIDTEMP/PIDTEMPBED is
enabled, PWM values rather than the target temperature determine whether
the heater is on.  I changed this to look directly at the PWM amount
when pid is enabled.

* Turn off heaters on M303 error

Currently, PID autotuning stops if it overshoots the temperature by 20C
or if if the temperature does not change for 20 minutes and it times
out.  I added calls to disable the heaters in these scenarios.

* Removed unnecessary if statement.

Added changes suggested by GMagician.

* Update temperature.cpp

* Update temperature.cpp

* Update temperature.cpp

(1.1.x) serious bug G33

[1.1.x] Revert default BABYSTEP_MULTIPLICATOR to 1

[1.1.x] Add MKS GEN L board

* auto tune calibration parameters

* solve warnings

* Tweaks to formatting

* review Thinkyhead

* Error

[1.1.x] Improved Firmware Retraction logic

Thanks @SCiunczyk

(bug fix) 1.1.x - save 1400 bytes of FLASH by using reduced font for some languages

* Initial conflict resolution

All previous items resolved:
- Use of ELAPSED() on timer code
- Switch to use of defer_return_to_status=true as much as possible
- Update & Clean Up of Max7219 routines

* Resolve non-SD case in ultralcd.cpp

* use reduced sized font for some languages

* Fit Portuguese language files to existing scheme

* Rename language_pl-DOGM.h to language_pl_utf8.h

* Rename language_pl_utf8.h to language_pl-DOGM.h

* Update dogm_font_data_ISO10646_1.h

* Update dogm_font_data_ISO10646_1.h

[1.1.x] Add MKS MINI 12864 support to GT2560

[1.1.x] Simplify mesh bounds config

[1.1.x] Fix position sync in M600 pause/resume

[1.1.x] Patch up some verbiage in configs

set_destination_to_current() changed to set_destination_from_current()

set_current_to_destination() changed to set_current_from_destination()

* Add M290 babystepping

* Allow `Z` for `M290`

* fix spacing

* Support BABYSTEP_XY in M290

* Not just Z

* Extend M290 for BABYSTEP_ZPROBE_OFFSET

* tweak

[1.1.x] Fix EndStops don't work with BOARD_RAMPS_14_EFB on Micromake C1

[1.1.x] Add SCROLL_LONG_FILENAMES to reveal longer filenames

Based on #7637 by @marcio-ao