Co-authored-by: Scott Lahteine <thinkyhead@users.noreply.github.com>

* Add support for MKS Robin TFT display

- Add support for MKS Robin TFT display and encoder for MKS Robin board.
- Generic 128x64 UI with x2 upscale is used (for now).
- Tested on MKS Robin TFT V2.0 with ST7789V controller.

* Group status methods, share reset_status with Extensible UI
* Move common DOGM code to headers

* Fixing the DUE serial port assignments: Now -1 means the SAM3x USB Device emulating a serial port, and 0 means the USB to serial adapter included as a programming port

* Improving the Fast IO port access implementation on Arduino DUE

* Implemented EEPROM emulation on Due by storing data on the internal FLASH (with wear leveling)

* Implemented a Software SPI for the ST7920 graphics display for the Arduino RAMPS for DUE, as the default one in u8glib is clocking data too fast on ARM, and the display does not understand it.

* Fixing the case where the serial port selected is the USB device

* Adding configuration for the Makerparts 3D printer (www.makerparts.net)

* Tuned MakerParts acceleration on X and Y axis so it never loses steps. Also adjusted pulses per mm to match default hw configuration

* Fine tuned Maximum acceleration for MakerParts printer

* Style cleanup

* Style cleanup (2)

* Style fixes (3)

* Fixing the DUE serial port assignments: Now -1 means the SAM3x USB Device emulating a serial port, and 0 means the USB to serial adapter included as a programming port

* Improving the Fast IO port access implementation on Arduino DUE

* Implemented EEPROM emulation on Due by storing data on the internal FLASH (with wear leveling)

* Implemented a Software SPI for the ST7920 graphics display for the Arduino RAMPS for DUE, as the default one in u8glib is clocking data too fast on ARM, and the display does not understand it.

* Fixing the case where the serial port selected is the USB device

* Adding configuration for the Makerparts 3D printer (www.makerparts.net)

* Tuned MakerParts acceleration on X and Y axis so it never loses steps. Also adjusted pulses per mm to match default hw configuration

* Fine tuned Maximum acceleration for MakerParts printer

* Style cleanup

* Style changes to u8g_dev_st7920_128_64_sw_spi.cpp

* Even more improvements to the FastIO HAL for DUE. Now WRITE() is 2 ASM instructions, if value is constant, and 5 cycles if value is not constant. Previously, it was 7..8 cycles

* After some problems and debugging, seems we need to align the interrupt vector table to 256 bytes, otherwise, the program sometimes stops working

* Moved comments out of macro, otherwise, token pasting does not properly work sometimes

* Improved Software SPI implementation on DUE: Now it honors the selected speed passed to spiInit(). This allows much faster SDCARD access, improving SDCARD menus and reducing latency

* Update u8g_dev_st7920_128_64_sw_spi.cpp

* Disabling EEPROM over FLASH emulatiion if an I2C or SPI EEPROM is present

Travis fix - only allow ultralcd_st7920_u8glib_rrd_AVR.cpp to compile when ST7920 selected

LPC1768 VIKI2 & RRDFG are working

looks like all SPIs are working

library change

sh1106 locks up

fixed lockup, started I2C SW com

pretty

re-org

restore a few files

make library happy

switched HAL version of rrd

fix travis error

travis error fixes

another travis fix

cleanup

minor update

one more

correct spacing in platformio.ini