Fixed an error where SDCARDDETECTINVERTED was being defined/undefined
improperly

Remove the 'Thermal Runaway Protection' section from .travis.yml

Insert Debug DRYRUN Repetier Host compatible

because its activated by default now.

Closes #2234.

Automatic versioning for Travis builds

Fix thermal protection state machine target temp. V2

Fix out_of_range_error()

Back to 1.0.3 dev - for now

Versioning

If the target temperature is changed then it would always stay in the reset state.
Thanks to @tonokip.

Replaces #2119

For sprintf_P() the first parameter has to be a `char*` not `const char*`.

consistency name for multiplier

replace extruder_multiply with extruder_multiplier
like feedrate_multiplier or volumetric_multiplier

Add a semicolon to make Z_DUAL_STEPPER_DRIVERS compile again.

Fix problem Width Cura

Replace U8GLI v1.11 with v1.17

Addes support for SDD1306 I2C OLED LCD

This reverts commit 2724baae8b.

Updated LCD wiki location.

In Travis we already test against 1.17.

Update ru translation

Signed-off-by: Alexey Shvetsov <alexxy@gentoo.org>

faster compare

Slight size reduction by adding idle()

Redo "invalid extruder" to save 304 bytes

- Use `setTargetedHotend` in `M200`, as with other commands that use
`T` for the extruder
- Synthesize the "invalid extruder" message, obviating several long
strings

Ignore unknown commands if they start with G, M, or T

Print active extruder with M105 for MAX6675

Separate the maximum integral power for the bed from PID_INTEGRAL_DRI…

Initialize the display earlier

Replace MSG_F? with MSG_N?

Update M33 for new gcode parser

To avoid double definitions.
I prefer to read N for Number not for Nozzle.

Was omitted when T0 is a MAX6675.

My PID_INTEGRAL_DRIVE_MAX was at 96, which was insufficient for my bed
to reach its intended temperature. The head requires a low maximum power since
I run on 24 volts and it has a somewhat low thermal mass.

Fix DEGREES macro