Co-authored-by: Scott Lahteine <thinkyhead@users.noreply.github.com>

* disable SD_CHECK_AND_RETRY when USE_USB_COMPOSITE is enabled

* Update Sd2Card.cpp

* Disable SD_CHECK_AND_RETRY with USE_USB_COMPOSITE

Co-authored-by: Scott Lahteine <thinkyhead@users.noreply.github.com>
Co-authored-by: Scott Lahteine <github@thinkyhead.com>

* Make ExtUI respect MAXTEMP limits
  - Temperatures are now clamped by MAXTEMP limits rather than arbitrary values.
* Speed up USB init, add status
  - Speed up USB initialization
  - Show status message if init failed
* Enable status messages for EXTENSIBLE_UI
* Adjust max limit to MAX_TEMP - 15
* Misc. tweaks to formatting, const, etc.

- Watchdog reset during SD Card initialization.
- Move `DebugMonitor` to `DebugMonitor_Due.cpp`.
- Since the watchdog is enabled on boot do extra resets during init.
- Have `thermalManager` do watchdog reset before its ISR starts to prevent reset.
- Ensure that timers are stopped before reprogramming them to address tone issues.
- Improve SAM3XE reset when reflashed through the native port.

Based on https://github.com/MarlinFirmware/Marlin/issues/8746#issuecomment-368471901 by @benlye

This will save some program memory with no speed lose

It seems that some SD cards don't support CRC_ON_OFF command. This fix will permit to use also these cards but leaving CRC check active on the system

* Merging early because of build failures.  See #8105

* Make LPC1768 pinmapping not specific to Re-ARM

* Add HAL_PIN_TYPE and LPC1768 pin features

* M43 Updates

* Move pin map into pinsDebug_LPC1768.h

* Incorporate comments and M226

* Fix persistent store compilation issues

* Update pin features

* Update MKS SBASE pins

* Use native LPC1768 pin numbers in M42, M43, and M226

This reverts commit 2dfa6ca72a.

Revert "Base HAL SPI Changes"

This reverts commit 2afc521b8b.

Revert "Initial HAL SPI API"

This reverts commit 58f7ffe09a.

Implement AVR Platform

Addressing #5806

If the watchdog is enabled and bootscreen + SD card checks take too long, Marlin may hang at boot time because of the reset loop. We have this happen all the time with the Anet board if no SD card is inserted.

Replace all fastDigitalRead/Write() with READ/WRITE()

Define SCK_PIN, MISO_PIN, MOSI_PIN in pins.h if not already defined in the pins_*.h files.

Remove these conditional pin definitions from the pin-files. They are now always defined.

Define separate sets of SPI-pins for AT90USB with and without Teensy support in fastio.h.
Likely this was the main reason for all that confusion about the AT90USB-SPI pins.