If ENDSTOP_INTERRUPTS_FEATURE is enabled this tries to set up interrupt routines
for all used endstop pins. If this worked without errors, `endstops.update()` is called
only if one of the endstops changed its state.

The new interrupt routines do not really check the endstops and react upon them. All what they
do, is to set a flag if it makes sense to call the endstop test we are used to.

This can be used on:
* ARM (DUE) based boards - all pins can raise interrupts,
* RAMPS - all 6 endstop pins plus some other on EXT-2 can raise interrupts,
* RAMPS based boards - as long the designers did not change the pins for the endstops or at least left enough,
* all boards, if there are enough pins that can raise interrupts, and you are willing/able to swap with pins dedicated to other purpose.

The flag is already set inside planner.get_current_block(). Doing it
twice isn't making it better..

・Update forgotten K8400\Dual-head\Configuration.h
・Adjust spacing

・Add new translation

・Remove all the #ifndef
・Follow the PR #4603 (Strip never-translated strings from language
files)
・Follow the PR #4634 (Set language display charset in language.h)
・Follow the PR #4936 (Put max_jerk vars in array, clean up jerk code)
・Adjust spacing

Add optional parameters
X, Y for probe point
S sets stowing on and off

Added a rule so that LIN_ADVANCE isn't used for moves with negative E movements (de_float will be negative in this cases).
I also added a more detailed comment to make it more clear what the if statement does.

- Allow more than 9x9 probe points
- Account for the probe starting position

bool feedback is no longer used

・Add CASE_LIGHT_PIN into pinsDebug.h

implemented G-Code M355 into Marlin

The extrusion speed was wrong due to a not high enough precision of
esteps to XY steps, therefore now the target float values are used to
calculate the ratio between XY movement and extrusion speed.
The e_speed_multiplier8 was replaced by an absolute multiplier called
abs_adv_steps_multiplier8, therefore one multiplication and bitshift can
be saved inside the stepper ISR. Due to this, also extruder_advance_k is
better suited inside the planner and not the stepper files any more.

see detailed  description in PR #5118

I stumbled across a name change that'll be used a lot so I'm updateing
the name list.