* Better section / function log
* Add do_z_clearance motion function

Saves 128 bytes in testing with `mftest mega 1 -y`

* Add Formbot Raptor board

Co-Authored-By: InsanityAutomation <insanityautomation@users.noreply.github.com>

* Add a second Z probe Z offset

Co-Authored-By: InsanityAutomation <insanityautomation@users.noreply.github.com>

* Modify method to utilize live adjustment of hotend z offset

Should probably move config option to babystepping and rename as it may now apply to all multiextruder systems

* Move config item and catchup other code to current method

- Move FWRETRACT to the planner
- Combine leveling, skew, etc. in a single modifier method
- Have kinematic and non-kinematic moves call one planner method

Use macros that explicitly avoid double-evaluation and can be used for any datatype, replacing `min`, `max`, `abs`, `fabs`, `labs`, and `FABS`.

Co-Authored-By: ejtagle <ejtagle@hotmail.com>

Co-Authored-By: ejtagle <ejtagle@hotmail.com>

Some "fix-mounted" probes need manual stowing. And after probing some may prefer to raise or lower the nozzle. This restores an old option but tailors it to allow raise or lower as preferred.

If using babystep to adjust the Z probe offset, the axis will move and the mesh will be updated at the same time, causing a doubling of the Z offset over the rest of the print.

To correct for this, the current Z position would need to be modified in the opposite direction, canceling out the additional Z offset added to the mesh. This would be confusing to users, and moreover it would not be accurate without also taking the current Z fade level and current Z height into account.

It might make sense to change the mesh in the case where no babystepping is taking place, but this could be considered an undesirable side-effect of changing the `zprobe_zoffset`.

One way to remedy this would be to return to storing the mesh with `zprobe_zoffset` included, then subtracting `zprobe_zoffset` from the returned Z value. Thus, a babystep moving the Z axis up 1mm would subtract 1 from `zprobe_zoffset` while adding 1 to all mesh Z values.

Without including the `zprobe_zoffset` in the `z_values` there is no safe way to alter the mesh in conjunction with babystepping, although it's fine without it.

set_destination_to_current() changed to set_destination_from_current()

set_current_to_destination() changed to set_current_from_destination()